revit里处理family的通常做法

《revit里处理family的通常做法》由会员上传分享，免费在线阅读，更多相关内容在教育资源-天天文库。

1、处理FAMILY一般做法TheWayofWorkingonFamilybySongLu选中所有的几何体,如图所示,点击上面的Visibility,Chooseallthegeometries,clickthevisibilityastheshowingabove.将被选中的几何体的Visibility全部关闭.Turnoffthevisibilityofallthegeometries.几何体的Visibility被关闭后,在各个视图里面其边线显示的都是灰色的.Afterturningoffthevisibility,theoutline

2、sofallthegeometriesshowgrey.在Hiddenline或者Shadingwithedges的模式下加SymbolicLine.SymbolicLine的线型和命名方式统一为:HC/PL/xx_SOLID_THIN,线粗用1.AddingsymboliclineunderthedisplaymodeofHiddenLineorShadingwithedgesThenamingstyleisHC/PL/xx_SOLID_THIN,andthelineweightis1.加完Symbolicline后再加MaskingR

3、egion,线型用InvisibleLine.Afteraddingthesymbolicline,addMaskingregion,thelinetypeisInvisibleLine.添加MaskingRegion的时候要注意的是MaskingRegion是围绕照物体外轮廓的一个封闭的线框。同时，注意几何体之间的缝隙。TheMaskingregionisaloopwhichisaddedaccordingtotheoutlineofthefamily.Meanwhile,pleasenoticethegapsbetweenthegem

4、etries.点击FamilyType,给Type命名.命名的方式为WxDxH,单位为英寸.ClickingtheFamilyType,creatinganewname.ThenamingstyleisWxDxH,theunitisinch.确认插入点的位置.选好参考线,并点击属性Confirmingthelocationoftheinsertingpoint;Choosingthereferenceplanes,clickingtheirproperty.在属性里面勾选DefinesOrigin,并确认.TurningontheDefi

5、nesOriginandclicktheOK.