jjf1096-2002引伸计标定器校准规范

《jjf1096-2002引伸计标定器校准规范》由会员上传分享，免费在线阅读，更多相关内容在行业资料-天天文库。

1、中华人民共和国国家计量技术规范JJF1096-2002引伸计标定器校准规范CalibrationSpecificationforCalibratorofExtensometers2002一11一04发布2003一02一04实施国家质量监督检验检疫总局发布JJF1096-2002广引伸计标定器校准规范.勺。.口.口.O.O.O.口.O.0.0.O.O.。‘。.飞八︺..六勺︺..叭心JJF1096-2002︾..么今︾CalibrationSpecificationfor.。岁么.‘，.‘，.‘、.‘，.‘，.‘，.‘，.‘，.‘，.‘，.‘，.‘，.‘，.‘，Cali

2、bratorofExtensometers本规范经国家质量监督检验检疫总局于2002年11月04日批准，并自2003年02月04日起施行。归口单位:全国几何量工程参量计量技术委员会主要起草单位:陕西省计量测试研究所参加起草单位:西安世纪测控技术研究所钢铁研究总院分析测试研究所本规范委托归口单位负责解释工It1096-2朋2本规范主要起草人:张磊(陕西省计量测试研究所)施纪泽(西安世纪测控技术研究所)王春华(钢铁研究总院分析测试研究所)JJF1096-2002目录1范围·································。·················

3、·········，····························⋯⋯(1)2引用文献··························‘····························‘·········‘··············一(1)3概述··························································································⋯⋯(1)4计量特性····················································

4、·······························⋯⋯(2)4.1测微头的刻线质量及各部分相对位置··········································⋯⋯(2)4.2上·下心轴的同轴度·································································⋯⋯(2)4.3分辨力··························································，·······················⋯⋯(2)4.4示值误差···

5、··，，·············，···········，·············································⋯⋯(2)4.5示值稳定性·····················，························································⋯⋯(3)4.6支架刚性·················································································⋯⋯(3)5校准条件··················

6、·····························，····································⋯⋯(3)5.1环境条件················································································⋯⋯(3)5.2校准项目和校准用设备································································，·⋯(3)6校准方法····································

7、···············，································⋯⋯(3)6.1测微头的刻线质量和各部分相对位置·············································⋯⋯(4)6.2上、下心轴的同轴度····································...................................(4)6.3分辨力································································