jjf1091-2002测量内尺寸千分尺校准规范

《jjf1091-2002测量内尺寸千分尺校准规范》由会员上传分享，免费在线阅读，更多相关内容在行业资料-天天文库。

1、中华人民共和国国家计量技术规范JJF1091-2002测量内尺寸千分尺校准规范CalibrationSpecificationforMicrometersforMeasuringInsideDimension2002一11一04发布2003一05一04实施国家质量监督检验检疫总局发布JJF1091-2002马.。尹。.O.0.0.口.0.O.0.O.O.伪0.0.0.测量内尺寸千分尺校准规范.。}JJF1091-2002.心。。。心}代替JJG378-1985CalibrationSpecificationfor.。}JJG23-1988.洲Mi

2、crometersforMeasuringInsideDimension本规范经国家质量监督检验检疫总局于2002年11月04日批准，并自2003年05月04日起施行。归口单位:全国几何量工程参量计量技术委员会主要起草单位:黑龙江省计量检定测试院参加起草单位:青海量具刃具有限责任公司本规JJF1091-2002本规范主要起草人:张黎平(黑龙江省计量检定测试院)梁玉红(黑龙江省计量检定测试院)马钟焕(吉林省计量检定测试院)参加起草人:刘文滨(黑龙江省计量检定测试院)张洪玲(青海量具刃具有限责任公司)李旭辉(黑龙江省计量检定测试院)JJF1091-2

3、002目录I范围·························································································⋯⋯(1)2引用文献··················································································⋯⋯(1)3概述···············································································

4、···········⋯⋯(1)4计量特性···············，····································································⋯⋯(2)4.1测力·······················································································⋯⋯(2)4.2刻线宽度及宽度差························································-·

5、···········⋯⋯(2)4.3微分筒锥面的端面棱边至固定套管刻线面的距离······························⋯⋯(2)4.4微分筒锥面的端面与固定套管毫米刻线的相对位置···························⋯⋯(2)4.5测量面的表面粗糙度··································································⋯⋯(2)4.6测量爪测量面的圆弧半径及素线平行度·········································

6、·⋯⋯(2)4.7示值误差·················································································⋯⋯(3)4.8校对用的环规直径偏差及直径变动量·············································⋯⋯(3)5校准条件······································。·············································⋯⋯(3)5.1环境条件·······

7、··········································································⋯⋯(3)5.2测量标准器及其他设备·······························································⋯⋯(3)6校准项目和校准方法·····································································⋯⋯(4)6.1测力···························

8、····························································⋯⋯(4)6.2