华为交换机链路聚合配置.doc

《华为交换机链路聚合配置.doc》由会员上传分享，免费在线阅读，更多相关内容在行业资料-天天文库。

1、拓朴图如上：要求1交换机Ａ的名字改成SW１交换机B的名字改成SW22SW1和SW2的E0/1和E0/2做端口聚合3Sw1的E0/7属于vlan2,E0/8属于vlan34SW2上面的E0/7和E0/8属于vlan2命令：一：PC机的配置（PC模拟的是linux系统）在PCA上面配置ipfconfigeth0192.168.2.1netmask255.255.255.0在PCB上面配置ipIfconfigeth0192.168.3.1netmask255.255.255.0在PCC上面配置ipIfconfigeth0192.168.2.2netmask255.255.

2、255.0在PCD上面配置ipIfconfigeth0192.168.2.3netmask255.255.255.0二：在交换机A上面的配置Sysview----------------------进入配置界面SysnameSW1-------------------------更改交换机名为SW1Superpasswordcisco--------------------------配置特权命令Vlan2--------------------------创建vlan2Porte0/7----------------------------------------

3、--把E0/7加入vlan2Quit-----------------------------------退出vlan2Vlan3----------------------------------------------创建vlan3Porte0/8------------------------------------------把e0/8加入vlan3QuitInte0/1--------------------------------------进入0/1接口Speed100---------------------------------------设置速

4、率Duplexfull------------------------------------设置双工Portlink-typetrunk--------------------------------把端口设置成trunkPorttrunkpermitvlanall--------------------------设置允许通过此trunk的vlanQuitInte0/2Speed100DuplexfullPortlink-typetrunkPorttrunkpermitvlanallQuitLink-aggregatione0/1toe0/2both------

5、----------------把e0/1和e0/2聚合  在交换机B上做的配置Sysview----------------------进入配置界面SysnameSW2-------------------------更改交换机名为SW2Superpasswordcisco--------------------------配置特权命令Vlan2--------------------------创建vlan2Porte0/7------------------------------------------把E0/7加入vlan2Porte0/8--------

6、----------------------------------把e0/8加入vlan2QuitInte0/1--------------------------------------进入0/1接口Speed100---------------------------------------设置速率Duplexfull------------------------------------设置双工Portlink-typetrunk--------------------------------把端口设置成trunkPorttrunkpermitvlanall

7、--------------------------设置允许通过此trunk的vlanQuitInte0/2Speed100DuplexfullPortlink-typetrunkPorttrunkpermitvlanallQuitLink-aggregatione0/1toe0/2both----------------------把e0/1和e0/2聚合总结：第一次配置时。PCDpingPCA时怎么也没通。后来查看命令解释。才发现少了一个命令：porttrunkpermitvlanall,默认无此命令，所以默认情况下，trunk干道只允许vlan1通过给vl