JJF 1128-2004 矢量信号分析仪校准规范

《JJF 1128-2004 矢量信号分析仪校准规范》由会员上传分享，免费在线阅读，更多相关内容在行业资料-天天文库。

1、汀盯释中华人民共和国国家计量技术规范工万F1128-2004矢量信号分析仪校准规范CalibrationSpecificationforVectorSignalAnalyzers2004一09一21发布2004一12一21实施国家质量监督检验检疫总局发布工1F1128-2004尹、矢量信号分析仪校准规范.。心..心。。.。心JJF1128-2004。.。。CalibrationSpecificationfor..洲七.‘，.‘，.‘，.‘，.‘，.‘，.‘，.‘，.‘，.‘，.‘，.‘，.‘，.‘，VectorSignalAnalyzers本规范经国家质量监督检验检疫总局

2、于2004年09月21日批准，并自2004年12月21日起施行。归口单位:全国无线电计量技术委员会起草单位:信息产业部电子601计量站本规范由归口单位负责解释JJF1128-2004本规范主要起草人:谢少锋(信息产业部电子601计量站)梁琼祟(信息产业部电子601计量站)参加起草人:杨桥新(信息产业部电子601计量站)JJF1128-2004目录1范围··························································································⋯⋯(1)2引用文献············

3、········································································⋯⋯(1)3术语和定义·················································································⋯⋯(1)3.1互调失真·················································································⋯⋯(1)3.2矢量坐标图···················

4、···········。···············································⋯⋯(1)3.3误差矢量·················································································⋯⋯(1)3.4误差矢量幅度······。····································································⋯⋯(1)3.5矢量幅度误差··································

5、·········································⋯⋯(1)3.6相位误差·················································································⋯⋯(2)3.71/Q原点偏移···········································································⋯⋯(2)3.8频率偏移·····················································

6、····························⋯⋯(2)4概述··························································································⋯⋯(2)5计量特性····················································································⋯⋯(2)6校准条件···························································

7、·························⋯⋯(3)6.1环境条件·················································································⋯⋯(3)6.2校准用标准器及其他设备··········。·····························。···········。·······⋯⋯(4)6.3其他要求·························································