YYT0064-2004 医用诊断旋转阳极x射线管电、热及负载特性_.pdf

《YYT0064-2004 医用诊断旋转阳极x射线管电、热及负载特性_.pdf》由会员上传分享，免费在线阅读，更多相关内容在行业资料-天天文库。

1、ICS11.040.50C43中华人民共和国医药行业标准YY/T0064-2004/IEC60613:1989代替YY/T0064-1991医用诊断旋转阳极X射线管电、热及负载特性Electrical,thermalandloadingcharacteristicsofrotatinganodeX-raytubesformedicaldiagnosis(IEC60613:1989,IDT)2004-11-08发布2005-11-01实施国家食品药品监督管理局发布.www.bzxzk.com.YY/T0064-2004/IEC60613:19

2、89目次前言····································································，················，······················⋯⋯工1范围和目的，·································，························，··············，·····················。。。···⋯⋯12引言···········‘······························

3、·············································，······················⋯⋯13术语和定义·································································································.··⋯⋯14X射线管的电特性·······································································..·.⋯⋯，..⋯⋯15

4、X射线管加载········，······。··········，··········，，，··············，甲-·········⋯⋯，，.·‘···一26输人功率················································································，························⋯⋯37阳极热特性······································································

5、·······························⋯⋯48X射线管组件热特性·······，，······································，··············.....·.....·........，...⋯⋯59X射线管摄影额定容量····，，1。。··········，，-··。··.，·····，甲甲，············甲甲，甲-············，.⋯⋯。‘.6附录A(规范性附录)已定义的术语索引·······················，············

6、······························⋯⋯9附录B(资料性附录)型式试验指导···········..................................................................11图1阳极最大热容量验证···，················，·················，·····，····················..·⋯⋯，二。.⋯⋯5图2阳极冷却曲线验证···············································

7、·································.·....⋯⋯5表1特性参量与单位一览表.www.bzxzk.com.YY/T0064-2004/IEC60613:1989月U吕本标准等同采用IEC60613:1989《医用诊断旋转阳极X射线管电、热及负载特性》(英文版)。为便于使用，本标准做了下列编辑性修改:—删除了国际标准前言和序;—“本国际标准”一词改为“本标准”。本标准代替YY/T0064-1991《医用诊断旋转阳极X射线管电、热及负载特性》。本标准与YY/T0064-1991相比主要变化如下:—增加了目次、前言

8、、术语;—在标准名称和术语后增加了英文原文;—编排顺序按IEC60613:1989;—为方便验证，在7.50H-h，后增加(或H40,h;后增加(或h:);在7,5d)H-h:后