桥梁挠度仪校准规范

《桥梁挠度仪校准规范》由会员上传分享，免费在线阅读，更多相关内容在行业资料-天天文库。

1、福建省地方计量技术规范JJF（闽）1077－2016桥梁挠度仪校准规范CalibrationSpecificationforBridgeDeflectionInstrument2016-01-15发布2016-03-15实施福建省质量技术监督局发布JJF（闽）1077-2016桥梁挠度仪校准规范CalibrationSpecificationforBridgeJJF（闽）1077－2016DeflectionInstrument本规范经福建省质量技术监督局于2016年01月15日批准，并自2016年03月15日起施行。归口单位

2、：福建省质量技术监督局主要起草单位：福建省计量科学研究院参加起草单位：北京光电技术研究所本规范由福建省计量科学研究院负责解释。JJF（闽）1077-2016本规范主要起草人：周志春（福建省计量科学研究院）刘震（福建省计量科学研究院）李巧丽（福建省计量科学研究院）参加起草人：孙海霞（北京光电技术研究所）JJF（闽）1077-2016目录引言··························································································（II）1范

3、围·····················································································（1）2引用文件···············································································（1）3术语·····················································································（1

4、）3.1挠度····················································································（1）3.2靶标····················································································（1）3.3光栅位移测量系统··································································（1）4

5、概述·····················································································（1）5计量特性···············································································（2）5.1挠度示值误差········································································（2）5.2靶标

6、灯中心距示值误差····························································（2）5.3挠度测量重复性·····································································（2）6校准条件·················································································（3）6.1环境条件·················

7、·····························································（3）6.2操作条件··············································································（3）6.3校准用设备···········································································（3）7校准项目和校准方法··················

8、··············································（3）7.1校准项目···············································································（3）