交科院测量放线方案修复的

《交科院测量放线方案修复的》由会员上传分享，免费在线阅读，更多相关内容在应用文档-天天文库。

1、新建山西省交通科学研究院产业化基地山西省第五建筑工程公司新建山西省交通科学研究院产业化基地测量放线方案编制人：审核人：审批人：山西五建新建山西省交通科学研究院产业化基地二零一三年四月七日新建山西省交通科学研究院产业化基地山西省第五建筑工程公司目录1、编制依据······················································32、工程概况······················································33、施工准备···························

2、···························43.1、场地准备····················································43.2、测量仪器准备················································43.3、技术准备····················································53.3.1、测量组织···············24/20新建山西省交通科学研究院产业化基地山西省第五建筑工程公司···········

3、························53.3.2、技术要求·················································63.3.3施测原则··················································64、主要施工测量方法··············································64.1、坐标及高程引入··············································64.1.1、坐标点、水准点引测依据·

4、····································74.1.2、场区平面控制网布设原则···································74.1.3引测坐标点、水准点，建立局域控制测量网·····················74.224/20新建山西省交通科学研究院产业化基地山西省第五建筑工程公司测量控制方法················································104.2.1、轴线控制方法······································

5、·······104.2.2、高程传递方法·············································104.2.3、轴线及高程点放样程序·····································104.3、基础测量放线···············································104.3.1、轴线投测·················································124.3.2、标高控制·························

6、························124.4、主体结构测量放线···············24/20新建山西省交通科学研究院产业化基地山西省第五建筑工程公司····························134.4.1楼层主轴线传递控制········································134.4.2、楼层标高传递控制·········································144.5、安装工程标高控制·····································

7、······144.6、测量注意事项···············································154.7、细部放样的要求·············································155、质量标准·····················································156、沉降观测与变形观测···········································1624/20新建山西省交通科学研究院产业化基地山西省第五建筑工程公司6.1

8、、沉降观测内容··············································1