YDT 1175-2001 通信电缆-同轴对绞混合电缆

《YDT 1175-2001 通信电缆-同轴对绞混合电缆》由会员上传分享，免费在线阅读，更多相关内容在行业资料-天天文库。

1、Yu中华人民共和国通信行业标准YD/T1175-2001通信电缆—同轴/对绞混合电缆TeleconununicationCable—HybridCoaxial/TwistedPairCable2001-12-11发布2001-12-11实施中华人民共和国信息产业部发布YD/T1175-2001目次前言······。·················。·························································································⋯⋯n1范围···。·····

2、·········一‘···································。·····················，··，···························⋯⋯12引用标准····················································································。····················⋯⋯13产品分类····························································

3、·············································⋯⋯24要求·················。······。··········。···。··················。····················································⋯⋯45试验方法·········································································································⋯⋯116

4、检验规则·············································。····。···········。··········································。··⋯147包装、包装标志、产品合格证、运输和贮存····························。·······························⋯⋯16YD/T1175-2001前言本标准主要根据美国贝尔通信研究公司的标准GR-2879-CORE《架空式同轴/对绞混合用户电缆一般要求》1995年版、GR-2949

5、-CORE《直埋式同轴2刚绞混合电缆一般要求》1997年版和美国绝缘电缆工程师协会标准ICEAS-91-674《直埋式同轴和同轴/对绞组合电线》1996年版编写的。本标准制定的产品结构型式、规格、用途、技术指标和性能要求与GR-2879-CORE.GR-2949-CORE和ICEAS-91-674相同。本标准的结构和编写规则按中华人民共和国国家标准GB/T1.1-2000《标准化工作导则第1部分:标准的结构和编写规则》的规定。同时，按照GB/T1.1-2000中关于引用文件的规定，其中多项条款直接引用了中华人民共和国通信行业标准YD/T897.1-199

6、7《接入网用同轴电缆第1部分:同轴用户电缆一般要求》(根据GR-1398-CORE制定的)、YD/T322-1996《铜芯聚烯烃绝缘铝塑综合护套市内通信电缆》和YD/'r837-1996《铜芯聚烯烃绝缘铝塑综合护套市内通信电缆试验方法》的相关条款。本标准为首次制定的中华人民共和国通信行业标准。本标准由信息产业部电信研究院提出并归口。本标准起草单位:大唐电信科技股份有限公司光通信分公司本标准主要起草人:虞春周霄山中华人民共和国通信行业标准通信电缆，一同轴声对绞混合电缆1'elecommunicationCable-HybridCoaxial/YD/T117

7、5-2001TwistedPairCable1范围本标准规定了通信电缆—同轴2对绞混合电缆(以下简称电缆)的产品分类、要求、试验方法、检验规则、包装及包装标志、运输和贮存等。本标准规定的产品主要用于将电话/多媒体线路从配线终端连接至网络接口设备或网络接口单元或用户，同轴缆单位用于传输视频、模拟信号和压缩的数字信号，同时也可传输高速数字信号，同轴缆单位的工作频率范围为5~1000MHz;对绞线单位通常用于传输音频、l50kHz及以下的模拟信号和2048kbit/s的数字信号，在一定条件下，其最高工作频率可至6.3MHzo2引用标准下列文件中的条款通过本标准

8、的引用而成为本标准的条款。凡是注日期的文件，其随后所有的修改单(不包括勘误的内容