JJF1123-2004基圆齿距比较仪校准规范.pdf

《JJF1123-2004基圆齿距比较仪校准规范.pdf》由会员上传分享，免费在线阅读，更多相关内容在行业资料-天天文库。

1、中华人民共和国国家计量技术规范JJF1123-2侧M基圆齿距比较仪校准规范CalibrationSpecificationforBaseCirclePitchComparator2004一06一04发布2004一12一01实施国家质量监督检验检疫总局发布JJF123-2004产基圆齿距比较仪校准规范弓一4.。心JJF1123-2004。‘，.。代替JJG78-1982悦CalibrationSpecificationfor.沪么.‘，.‘，.‘，.‘，.‘，.‘，.‘，.‘，.‘，.‘，.‘二.‘忿.‘，，‘

2、，BaseCircle巧忱hCator本规范经国家质量监督检验检疫总局于2004年06月04日批准，并自2004年12月01日起施行。归口单位:全国几何量长度计量技术委员会起草单位:东风汽车公司计量所本规范由归口单位负责解释JJF1123-2004本规范起草人:郑旭(东风汽车公司计量所)JJF1123-2004目录1范围·...............................................................................................

3、(1)2引用文献····················································································⋯⋯(1)3概述··························································································⋯⋯(1)4计量特性。·。·······，··············································

4、，··························⋯⋯(2)4.1前、后校对块工作面的平面度···。·························。························⋯⋯(2)4.2前、后校对块工作面的平行度·...........................................................(2)4.3前、后校对块工作面的研合性······················································⋯

5、⋯(2)4.4前、后校对块工作面的重合性······················································⋯⋯(2)4.5指示表·············。······································································⋯⋯(2)4.6重复性·............................................................................

6、.............(2)4.7示值误差········································。······································。·⋯⋯(2)5校准条件·········，·········。·······，······，····。······⋯⋯“·······························⋯⋯(2)5.1环境条件························。··························

7、······························⋯⋯(2)5.2校准项目和标准器·····································································⋯⋯(2)6校准项目和校准方法·.....................................................................·一(2)6.1前、后校对块工作面的平面度·...................................

8、........................(3)6.2前、后校对块工作面的平行度···，···，···············，············，·，】··········，，二(3)6.3前、后校对块工作面的研合性······················································⋯⋯(3)6.4前、后校对块工作面的重合性···········