3、的过程。最后得出所需要的相应数据图像，为设计者提供良好的设计和修改平台。本书利用软件首先画出三维图形，然后将重要的数据添加到数据框中在之后的设计中只需修改数据便可以快速的得到所需要的齿轮。然后通过装配将两齿轮装配起来，再利用软件做仿真得出运动时的位置、速度、加速度的图像。关键词：Pro/E，齿轮，模数，齿数，压力角，运动仿真。49ABSTRACTThis subject is about the process of making three-dimensional modeling and motion simulation of Pro / E gear.
4、 After changing some parameters of the teeth, the modulus and so on, the three-dimensional model of the gear created by Pro / E software can help to quickly generate the required gear design. Under the same modulus and pressure angles, selecting the center axis that connects the pin
5、 and the gear shaft as a positioning reference.After gear assembly is completed, it is necessary to do interference analysis to determine the reasonableness of the assembly . Then define the gears and create a driver. Finally, analysis and simulate the kinematics and dynamics of me
6、chanical systems to determine the position.KeyWords:Pro / E, gear, modulus, number teeth, pressure angle, motion simulation.49目录第1章绪论11.1 概论11.2 齿轮的传动概述2第2章直齿圆柱渐开线齿轮的建模32.1 渐开线齿轮的齿廓建模32.2 齿槽的阵列132.3 特征的设计142.4 创建齿轮218第3章齿轮传动仿真与分析203.1 齿轮的装配203.2 齿轮仿真及分析22第4章结论及展望284.1 结论284.1 展望28参考
