tbt 1864-2005 驼峰车轮传感器通用技术条件

《tbt 1864-2005 驼峰车轮传感器通用技术条件》由会员上传分享，免费在线阅读，更多相关内容在行业资料-天天文库。

1、Ks45.020;93.100SRFTB中华人民共和国铁道行业标准TB/T1864-2005代替TB/T1864-1987驼峰车轮传感器通用技术条件Thegeneraltechnicalrequirementsofwheeldetectorforautomatichumpyard2005-03-29发布2005-07-01实施中华少又民共和国铁道部发布TB/T1664-2005目次前言·........................................................................

2、.........................................II1范围·..............................................................................................................12规范性引用文件································································································⋯⋯13术

3、语和定义········································································································一14产品分类····················································································，····················⋯⋯25技术要求·······································

4、········································，····，····················⋯⋯26技术性能的试验方法·····································，······························⋯⋯““··⋯⋯“”’“’“47型式试验的内容和方法························································································一58检验规

5、则··················································································，······················⋯⋯79标志、包装、运输、贮存·························································································⋯⋯8TB/T1864-2005月q舀本标准代替TB/1'1864-1987((CYL型车轮永磁传感器》。本标准与

6、TB/T1864-1987相比主要变化如下:—规定了各种驼峰用车轮传感器的通用技术条件;—取消了特定车轮传感器的各种具体技术指标的规定;-一从驼峰控制系统及编组站运营要求出发，提出对所有车轮传感器的技术性能、适应性、可靠性和可维护性的要求。本标准由中国铁路通信信号集团公司西安铁路信号研究所提出并归口。本标准起草单位:铁道科学研究院通信信号研究所。本标准主要起草人:汤百华、张福信、张洪琦。本标准于1987年首次发布，本次为第一次修订。TB/T1864-2005驼峰车轮传感器通用技术条件1范围本标准规定了铁路编组站驼峰车轮传感器(以

7、下简称车轮传感器)、车轮传感器安装装置(以下简称安装装置)、车轮传感器信号处理电路(以下简称信号处理电路)的分类、主要技术要求、试验方法、检验规则等。本标准适用于车轮传感器及其安装装置、信号处理电路的研究、设计、制造和维修。2规范性引用文件下列文件中的条款通过本标准的引用而成为本标准的条款。凡是注日期的引用文件，其随后所有的修改单(不包括勘误的内容)或修订版均不适用于本标准，然而，鼓励根据本标准达成协议的各方研究是否可使用这些文件的最新版本。凡是不注日期的引用文件，其最新版本适用于本标准。GB/T2423.1-2001电工电子产

8、品环境试验第2部分:试验方法试验A:低温GB/T2423.2-2001电工电子产品环境试验第2部分:试验方法试验B:高温GB/T2423.4-1993电工电子产品基本环境试验规程试验Db:交变湿热试验方法GB/T2828.1计数抽样检验程序第1部分:按接收质量限