jjg951-2000模拟式温度指示调节仪检定规程

《jjg951-2000模拟式温度指示调节仪检定规程》由会员上传分享，免费在线阅读，更多相关内容在行业资料-天天文库。

1、中华人民共和国国家计量检定规程JJG951-2000模拟式温度指示调节仪AnalogueTemperatureIndicatorsandControllers2000一05一08发布2000一10一01实施国家质量技术监督局发布JJG951-2000模拟式温度指示调节仪产0.O.O.O.0.O.O.O.0.O.O.O.0.O.又.燕划弓.叭切.己么检定规程功弓.人劝.圣JJG951-2000八︺c.叭︺.VerificationRegulationofAnalogue弓八，b.口TemperatureIndicatorsandController

2、s本规程经国家质量技术监督局于2000年05月08日批准，并自2000年10月01日起施行。归口单位:全国温度工作器具计量技术委员会主要起草单位:上海市计量测试技术研究院杭州市质量计量监测中心参加起草单位:杭州晶达电子技术公司JJG951-2000本规程主要起草人:朱家良(上海市计量测试技术研究院)卢仲碧(上海市计量测试技术研究院)李行(杭州市质量计量监测中心)须君恒(杭州市质量计量监测中心)参加起草人:管志初(杭州晶达电子技术公司)徐承梅(杭州晶达电子技术公司)JJG951-2000目录范围···························

3、·······················································，·····⋯⋯(1)术语············....................................................................................(1)1标称电量值····，·····································⋯⋯，’····························⋯⋯(1)2设定点误差·········.........

4、.................................................................(1)3切换值····································，···············································⋯⋯(1)4切换差······························································。············。········⋯⋯(1)5时间比值(司...............

5、...............................................................(1)6非线性系数(二)·····································································⋯⋯(1)7零周期··········，，·····。·····，·····。··················，································⋯⋯(1)8比例带·································

6、··················································⋯⋯(1)9再调时间(积分时间)··········································，····················⋯⋯(1)10预调时间(微分时间)....................................................·····⋯⋯(2)11静差································································

7、····················⋯⋯(2)12干扰系数························································，····················⋯⋯(2)概述··································。······················································⋯⋯(2)计量性能要求·····························································

8、················⋯⋯(2)1指示基本误差(最大允许误差)············，··。··，·········。···